8
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
ASSEMBLY
VERTICAL TOWER [B] TO MAIN BASE UNIT [A]
Reference FIGS A AND B
• Place the square flange of the Vertical Tower
[B]
onto the Main Base Unit
[A]
with the four corner holes aligned over the four M12 studs of the
Main Base Unit. Note that the Pivoting Arm of the Vertical Tower must face the front end of the Main Base Unit.
• Use the four M12 Nuts
[C]
and Washers
[D]
and tighten securely with a 17mm wrench (not included).
SLIDE SHAFT SPRING [E] TO SLIDE SHAFT “BB”
Reference FIGS A AND B
Remove the M10 Socket Head Cap Screw and the Spring Cap
“cc”
from the top of the Slide Shaft with an 8mm Hex Key (not included) and set aside “for
re-installation.
• Rotate the Lock Lever
“aa”
90° from a vertical position down to horizontal to unlock the Slide Shaft
“bb”
.
• Raise the Slide Shaft
“bb”
fully, rotate the Lock Lever
“aa”
up 90° to a vertical position to lock the Slide Shaft in place.
• Slip the Slide Shaft Spring
[E]
down over the Slide Shaft
“bb”
.
• Re-install the Plastic Spring Retaining Cap
“cc”
over the end of the Slide Shaft and re-install the M10 Socket Head Cap Screw.
NOTE:
Some moderate pressure may be required to hold the Spring Cap
“cc”
in place while installing screw.
• Slip the Plastic Cover
[F]
down over the Slide Shaft and snap into place on the metal
bracket of the Lock Lever assembly.
INSTALL MOUNT/DISMOUNT SHOE, HORIZONTAL [G] AND VERTICAL [H] PLASTIC GLIDES
• Snap the Mount/Dismount Shoe
“dd”
,
“Ducktail”
Replaceable Plastic Glide
[G]
(
smaller
Glide) into the horizontal slot of the Mount/Dismount Shoe
(FIG 1)
.
• Install the Mount/Dismount Shoe
“Duckhead”
Replaceable Plastic Glide
[H]
(
larger
Glide) into the vertical recess of the Mount/Dismount Shoe
(FIGS 2&3)
by removing the retaining set-screw with a 2mm hex key (not included).
INJURY HAZARD!
•
The Tire Machine consists of large moving components which can present hand/finger pinch hazard injuries if dropped.
•
Avoid pinching hands while handling parts during assembly and/or operation.
Never operate the Tire Changing Machine without these Glides in place
or severe damage to the wheel rim edge and face will occur.
FIG. 1
FIG. 2
FIG. 3
✓
G
“dd”
✓
“dd”
✓
✓
H
Duckhead
Set Screw
Ducktail
H
“dd”
G
✓
✓
✓
✓
✓
✓
PINCH AND CRUSH HAZARD!
Keep fingers and hands away from moving parts when operating.
