To order parts and supplies: 800.345.1178 >> eastwood.com
5
SET-uP
• After the desired current source is determined, be sure the proper plug is
used and the appropriate circuitry and breakers are in place.
• Do not plug unit in at this time and make sure the Power Switch on the left
side of The Front Panel is in the OFF position. (Fig. A)
• Install an air fitting compatible with your air line into the 1/4” NPT fitting on
the rear of the plasma cutter. (Fig. B)
• Attach the Torch Air Supply Line to the lower left of the front panel and
tighten. (Fig. C)
• Attach the Torch Switch Connector Cable to the Multi-Pin Connector located
on the third from left of the lower front panel. (Fig. C)
• Remove the black threaded knob (2nd from left) and place the terminal of
the red lead over the post, then replace the knob and tighten. (Fig. C)
• Attach the Ground Lead Connector to the terminal located at the lower right
of the front panel. (Fig. C)
FIG. B
FIG. C
FIG. A
Ground
Torch
Switch
Connector
✑✒✓
✔
✑✒✓
✔
Pilot Arc
Ignitor
Torch Air
Supply Line
✑✒✓
✔
✑✒✓
✔
