Eastwood 12740 Assembly & Operating Instructions Download Page 3

To order parts and supplies: 800.345.1178  >>  eastwood.com 

3

SAFETY INFORMATION

FLAMMABILITY HAzARD 

•  Before beginning, make sure the work surface is cleaned of any oils, coatings or other materials which can ignite and or emit 

dangerous fumes or vapors.

•  Molten metal is ejected away from the cutting area with significant force and speed. Make sure the entire work area is clear from 

flammable or easily damaged materials or objects.

HIGH VOLTAGE DANGER 

•  The unit contains no user serviceable parts! Contact with the torch when the button is depressed will result in a serious shock 

and severe burns! 

•  This device also produces High-Frequency, Radio-Frequency Emissions which can damage sensitive electronic equipment in the 

area. Keep all cell-phones, cameras, watches and other electronic equipment at least 6 feet away from the Power Unit and Torch. 

•  Important Note:

 If you have a medical condition or pacemaker check with your doctor before using as the RF emissions may 

cause interference. 

ELEcTRIcAL SAFETY TIPS

ELECTRICAL SAFETY DO’S 

•  Make sure you, your work area, and your equipment are dry. 

•  If you are using an extension cord (not recommended), make sure it is a grounded cord in sound condition with no damage or 

frays, and of the correct wire gauge (minimum 12 Gauge @ 25’ maximum length).

•  Ensure that proper sized circuit breakers and wiring are in place prior to use: 20 Amp for 120 volt operation and 30 Amp for  

240 volt operation.

ELECTRICAL SAFETY DON’TS 

•  Never bypass the ground plug. Grounding is necessary for proper operation of the unit and reduces shock hazard. 
•  Do not touch the torch tip until after the activation switch is off and the unit is UNPLUGGED.

•  Do not use the unit if any component should become damaged or show signs of excessive wear.

DANGER WARNINGS!

READ AND UNDERSTAND ALL INSTRUCTIONS AND PRECAUTIONS BEFORE PROCEEDING.  

This unit emits a powerful high voltage and extremely high temperature plasma arc of superheated air which can cause severe burns, 
dismemberment, electrical shock and death. Eastwood shall not be held liable for consequences due to deliberate or unintentional 
misuse of this product.

Summary of Contents for 12740









Reviews: