Eastsign ROT Series, User Manual

Page: 4 / 23

Eastsign
R
O
TAR
Y
HE
AT
PRE
SS
R
OT
-M
U
SER
MA
NU
A
L
2
2. Safety Instruction
Before the operation, please read the safety instruction carefully to fully understand the machine’s primary
structure, function, and operation method. If conditions permit, the training to the operators is required, and
the operators, passing the examination, are allowed to operate and maintain. During the operation and
maintenance, please pay attention to the warning signs, pasted to the equipment, and improve the safety
awareness to prevent the accidents and to guarantee operator’s personnel safety.
2.1 Safety parts
2.1.1 Heat switch and Power switch
Heat switch and Power switch both are on the control panel. Press the heat power to stop the heating
immediately. Turn off the power button; the machine can not get the power for heating, but the machine can
get power for revolving the motor.
2.1.2 Separating blanket Switch
When the heat transfer finishes its working, turn off heating and keep motor rotating until the temp decline
under 80
℃
to prevent the blanket from burning.
2.1.3 Heating Roller
Following heating, the surface temperature of the heating roller could be up to over 240
°
C. While it is
heating, please don
’
t touch the roller surface with any part of the body to avoid crushing or burning. When the
machine is heating and operating, the operators shall be present to avoid the roller damages or the fire due to
the overheating.
2.2 Warning Sign
Please pay attention to the following warning signs. The cases shown in the signs are likely to cause machine
damages or injuries of the operators.
Anti-grinding
This sign is shown at the junction of the upper and lower drive
rollers, respectively at the both sides of the machine front. The
rubber roller in operation is relative dangerous. Please don’t let
your hand, clothes, hair or other parts of your body touch it to
avoid incident.