20 Adjustments
5. Go to the rear of the L-sealer. Make sure the head cylinder is straight from front
to back. Pull the air cylinder bracket the full length of the air cylinder. Tighten the
5
/
16
-inch set screws.
6. Cycle the seal head up and down. Adjust set screws on head return cylinders for
proper head speed and cushion.
Timers and Temperature Controls
Check dwell and conveyor-run timing, and temperature of front and side seals after
making adjustments or after performing maintenance, such as replacing seal pads,
cutting rules or hot knife inserts. Adjust as required using the adjustment provided
through the control panel.