30 Maintenance
Step 1
– Begin splicing in the center
1. Move the two ends of the belt to be spliced to the exit end of the conveyor.
2. Confirm that the edge loops curve back, away from the direction of belt travel as
shown in the following illustration. If not, check to make sure that the belt is not
positioned backwards on the conveyor.
3. Lay the strand down between the two belt ends and check to see that the edge
loops are going in the same direction as the belt edge loops. (The strand must also
be right-side-up for it to lay flat. You will know immediately if you have installed the
splice strand wrong-side-up and you will need to start over.)
4. Bend the strand from each side enough to insert the ends into the two spaces next
to the center space. (Spaces B and D in the following illustration.)
5. Insert the strand ends into the center space of the opposite edge. (Space 3 in the
illustration below.)
D
ire
cti
o
n
o
f
B
e
lt
T
ra
vel
Far Edge
Near Edge
A
E
C
B
D
2
4
1
5
3
Summary of Contents for ET1608-30
