9
10
5. MEASURMENT OPERATION
①
Hold the meter by its
Handle Grip
and point it toward the
surface to be measured.
②
Pull and hold the
Trigger
to turn the meter on and begin
testing. The display will light if the battery is good. Replace
the battery if the display does not light.
③
While measuring, the SCAN display icon will appear in the
upper left hand corner of the LCD.
④
While continuing to pull the Trigger:
a. Push the
Laser
button to turn on the laser pointer. When the
laser is on the laser icon will appear on the LCD over
the temperature. Aim the red beam approximately a half inch
above the point of test (pressing the Laser button again turns
the laser off).
b. Select the temperature units (
o
C or
o
F) using the
o
C
and
o
F
buttons.
c. Push the
Backlight
key to turn on the LCD backlighting
function.
⑤
Release the Trigger and the HOLD display icon will appear
on the LCD indicating that the reading is being held.
⑥
The meter will automatically power down after approximately
7 seconds after the trigger is released.
Note: Measurement considerations
Holding the meter by its handle, point the IR Sensor toward the
object whose temperature is to be measured. The meter
automatically compensates for temperature deviations from
ambient temperature. Keep in mind that it will take up to 30 minutes
to adjust to wide ambient temperatures are to be measured
followed by high temperature measurements, some time (several
minutes) is required after the low (and before the high) temperature
measurements are made.
This is a result of the cooling process which must take place for the
IR sensor.
6. BATTERY REPLACEMENT
①
As battery power is not sufficient, LCD will display “ ”
replacement with one new battery type 9V is required.
②
Open battery cover, then take out the battery from instrument
and replace with a new 9-Volt battery and place the battery
cover back.
Low battery indicator
Open the battery cover
9V battery
www.eastern-energy.com
