Easson ES-1M, Operation Manual

Page: 93 / 114

Easson
ES-1M
R
R
sin cos tan cal
M
in
M
R
1 2 3
4 5 6
7 8 9
ce
abs
inc
sdm ref
1/2
in
mm
ent
X
0
Y
0
Z
0
X
Y
Z
0 0.00
0.000
Z 197.00
- 89 -
Move the X axis until display
= 0.000, then the tool is
positioned on the ARC curve
shift left The display will
to signify it is not normal
co-ordinate display.
If the axis is positioned outside the curvature, will display " " ( Z R ES-1 Z OU LI Z OUT LIMIT )
Z axis simulated height
Z dial turn number
Z dial reading
move the Z axis
according to the dial
settings displayed
on Y axis
Display data in plane machining mode XZ R
X = 0.000
X = 0.000
Two axis ES-1 - ARC machining mode Two axis ES-1 - ARC machining mode
During the XZ or YZ plane R machining, it is necessary to carefully position the Z axis to obtain a precise
Z position. As, there is no Z axis in the two axis ES-1, and, in order that the operator can easily guide and
position the Z axis during the ARC machining, the ES-1 uses the unused axis display to display the
and
At the beginning of the ARC machining, the ES-1 will assume the Z axis dial at zero position with the tool
positioned at the starting point of the ARC. Press the and once to simulate Z axis move up or
down for one step - the corresponding Z dail turn number and Z dial reading will display on the unused
axis. The operator must move the Z axis according the dial reading display on this axis, then the correct
Z axis height is reached..
Z dial
turn number Z dial reading.
Easson