three marks are leveled.
Mark a point
(3)
on the horizontal line
C
,
80
mm to the right of the vertical reference line.
Repeat this operation on the other side, checking that the two marks are leveled.
Fix the brackets (Optional):
Drill at the marked points
(1) (2) (3)
, using a ɸ10 mm drill bit.
Insert the Wall Plugs
11
into the holes
(1) (2) (3)
.
Fix the hood fixing bracket
20
with 3 screws
10
(5 x 50) supplied with the hood.
Fix a Chimney fixing bracket
21
with 2 screws
10
(5 x 50) supplied with the hood.
Hook the hood body:
Open the panel.
Remove the Metal grease filter using the handles provided.
(Either) Hook the hood body to the bracket
20
.
(Or) Hook the hood body to the screws
10
(5 x 50)
at the points (2).
Level the hood body itself.
From the inside of the hood body, fix the screws
10
to Wall Plugs 11 at the points
(3)
.
Fit the filter into the hood.
Close the panel.
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney
using either a flexible or rigid pipe ɸ 150 or ɸ 120 mm, the choice of
which is left to the installer.
To install a ɸ 120 mm air exhaust connection, insert the reducer
flange
3
on the hood body outlet.
Fix the pipe
4
in position using sufficient pipe clamps (not
supplied).
Remove possible charcoal filters.
Right
Wrong
EN-6
V.5
