CAUTION:
Auger does not stop immediately after the
snow thrower is turned off.
CAUTION:
Risk of injury. Do not put hands, feet or
any body part or clothing near the rotating auger.
WARNING: California Proposition 65:
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.
WARNING:
Cancer and Reproductive Harm
-
www.P65Warnings.ca.gov.
If extension cord must be used, make sure:
a.
That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger
b.
That extension cord is properly wired and in good
condition; and
c.
That wire size is large enough for AC ampere
rating of charger as specified below:
Cord length (Feet)
-
25’ 50’ 100’
Cord Size (AWG)
-
16 16 16
NOTE: AWG= American Wire Gauge
Save these instructions. Refer to them frequently and
use them to instruct others who may use this product.
If you loan someone this snow thrower, loan them
these instructions also.
WARNING:
Keep all connections dry and off the
ground. Do not touch plug with wet hands.
If the snow thrower starts to vibrate abnormally, turn it
off immediately and check for the cause. Vibration is
generally a warning of trouble.
Always turn off the snow thrower, remove the battery
from the snow thrower and wait until the auger comes
to a complete stop before carrying out maintenance or
repairs.
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk
of electric shock.
Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a risk
of fire, electric shock, or injury to persons. Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
Do not service snow thrower with battery, switch key,
or charger installed.
Do not use the charger when the ambient temperature
is above 37.8
°
C (100°F) or below 0
°
C (32°F)
Do not operate charger with a damaged cord or plug
which could cause shorting and electric shock. If
damaged, replace the charger with an identical
charger.
Do not operate charger if it has received a sharp blow,
been dropped or otherwise damaged in any way.
Take it to a qualified individual for electrical check to
determine if the charger is in good working order.
Unplug charger from outlet before attempting any
maintenance or cleaning to reduce the risk of electric
shock.
Disconnect charger from the power supply when not
in use to prevent damage to the charger during a
power surge.
Risk of electric shock, Do not touch uninsulated
portion of output connector or uninsulated battery
terminal.
Do not expose charger to wet or damp conditions,
Water entering charger will increase the risk of electric
shock.
Make sure cord is located so that it will not be stepped
on, tripped over, come in contact with sharp edges or
moving parts or otherwise subjected to damage or
stress. This will reduce the risk of accidental falls,
which could cause injury and damage to the cord,
which could result in electric shock.
Keep cord and charger away from heat to prevent
damage to housing or internal parts.
Do not let gasoline, oils, petroleum
-
based products,
etc. come in contact with plastic parts. They contain
chemicals that can damage, weaken or destroy
plastic.
An extension cord should not be used unless
absolutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock.
GENERAL SAFETY
SAFETY RULES FOR CHARGER
FCC WARNING:
Please note that changes or modifications to this
product not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
--
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
--
Consult the dealer or an experienced radio/TV
technician for help.
4
Model SN74016
