Assembly and Operation Instructions
Earthway_M20 Manual
PAGE 2
Assembly Instructions:
STEP 1:
Unpack all parts from shipping carton to ensure no parts are missing. Refer to the exploded view.
STEP 2:
Install the four (#9) 7/8” Tube plugs onto the ends of the two (#15) Frames with the help of a hammer or some
other tool.
STEP 3:
Determine whether to mount on the front or the back of the luggage rack. Depending on whether the M20 is
mounted to the front or rear rack, you will need to install (#4) Control assembly to either the right (#11) or left (#15)
Frame tube to allow for use with the non-throttle hand. Wait until the unit is mounted to the Quad before installing the
Control.
STEP 4:
Next install four 1/4-20 x 1-
1/2” Carriage bolts (#12) through the Hopper assembly and then through
ONE
of
either side Frame and secure with 1/4-20 Hex Nut (#8).
STEP 5:
Now position the M20 to the Quad and install the
remaining Frame member as outline above in
STEP 4.
Now
install the Control assembly (#4) to the Frame and secure with a
1/4-20 x 1-
3/4” Carriage bolt (#13) and 1/4
-20 Hex Nut (#8) and
tighten firmly to allow movement, but not allow the lever to
move unassisted.
Now install the M20 on your quad as outlined on the following
page.
WARNING
KEEP HANDS AWAY FROM ANY SPINNING OBJECT, SHUT-OFF PLATE, SHUT-OFF MECHANISM LINKAGE, AND THE
INSIDE OF THE HOPPER, EXTREME INJURY CAN OCCUR.
