16.
For normal operation both doors should be fully opened. To reduce flow to the left side, partially or completely close the door over the rear
(
LARGE
) hole. To reduce flow to the right side, partially or completely close the door over the front (
SMALL
) hole. Close both doors for a
narrow center spread pattern.
WARNING:
If the optional side deflector is being used in the down position, the plate over the rear (
LARGE
) hole
MUST BE CLOSED
or
an over application of material will occur.
PAGE 5
The settings furnished on the Setting Matrix are intended as a guide only. Variations in physical characteristics of material applied, walking
speed, and roughness of ground surface may require slightly different spreader settings. Due to these conditions, Earthway Products, Inc.
makes no warranty as to the uniformity of coverage actually obtained from the settings listed.
Sp
read
Patter
n
Infinitely Variable
Throwing Port Openings
One port closed
Both ports closed
Both ports open
Constant Spread Width
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader.
5
Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or from our web site
under the MANUALS SECTION.
5
Move stop bolt on rate gauge assembly to the proper setting.
5
While pushing spreader forward, pull control lever back to stop bolt.
5
To stop, push lever forward to close flow holes before you stop moving.
5
When finished, empty any remaining material from hopper.
5
Thoroughly wash spreader and allow to dry before storing. A coating of light oil will help prevent corrosion.
5
If you use Rock Salt,
REMOVE THE AGITATOR
to prevent damage to the gearbox.
You now can register your product via email:
Please keep the original purchase receipt because it
will be needed if you need warranty coverage.
HOW TO ORDER SPARE PARTS
All spare parts listed may be ordered direct from
Earthway Products, Inc.
Be sure to give the following information when ordering.
Model Number
Part Number
Part Description
Call (574) 848-7491, 800-294-0671,
or email: [email protected] for current prices.
FULL Rate
HALF Rate
SPREAD PATH
© 2012 Earthway Products, Inc. All rights reserved
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-Years to the end user
with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc. at its discretion will repair or
replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering,
or normal wear and tear as determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along
with the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty. Do not return
any product without first receiving authorization from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway
Products, Inc. at 574-848-7491, [email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507
and describe the nature of the manufacturing defect.
SPECIFIC LIMITATIONS:
This warranty covers only the part(s) or product;
any labor charges associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of
most fertilizers and ice melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product
degradation or failure due to corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure,
coat all metal parts with a light oil or silicon spray.
