6.
Install drive wheel to axle using pin hole nearest to lower
handles as shown. Insert 2” cotter pin through wheel and
through axle. Bend with pliers to prevent pin from falling
out.
NEXT
Install coast wheel to axle, and then using outside pin
hole on the axle (as shown on the left), insert 1” cotter pin
through axle
[
NOTE
: not thru the wheel
]. Bend with pliers
to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS
2” Cotter Pin
1” Cotter Pin
If you have any questions
please call 1-574-848-7491
¼-20
Lock Nut
and
(Cupped Washer
for C22HD)
¼-20 x 2¾”
Hex Head Bolt
¼-20 x 2¼”
Hex Head Bolt
and (Cupped Washer
for C22HD)
2 Position Handle
Lower Position
Upper Position
7. NOTE: BEFORE INSTALLING THE GAUGE & LEVER ASSEMBLY AND UPPER HANDLE TO
THE HANDLE SHAFT, SELECT THE BEST POSITION FOR THE OPERATOR’S COMFORT.
You
can select lower or upper positions for best fit to the operator’s height. Insert 2¾” bolt through the Gauge,
then upper handle and finally through handle shaft. See example to the right.
DO NOT TIGHTEN LOCKNUT YET.
8.
Insert pivot rod into shut off plate as shown above.
[
TIP
: Insert rod end from the top, then push down &
turn to lock in place.]
9.
Insert other end of pivot rod into pivot and bracket assembly as shown.
[
TIP
: Insert rod end from the side
that has the angle attached to the bracket, then turn to lock in place as shown at the right and above. The
correct positioning of the Pivot Bracket has the Angle and Attaching Arm facing away from the gearbox.]
PAGE 3
Angle
Attaching
Arm
Insert Pivot Rod
into Shut-Off
and rotate to secure
