Assembly
and
Operation Instructions
Steps
1. Tape the drilling template on the wall at a convenient height, making sure the
holes are between studs.
2. Check the hole centers with the level to ensure they are plumb.
3. Drill (4) four holes with a 10mm (3/8in) masonry drill bit on the template centers.
4. Tap plas c anchors (B.3) into holes with a hammer or mallet.
5. Fasten the moun ng bracket with four lag bolts and washer to the wall or
mber post and ensure drive moun ng screws into the plas c anchors) in
wall.
6. Hang the hose reel on the wall bracket and secure it by inser ng the
mount tube.
7. Connect with inlet hose end with the water source.
EarthWay 14075 – 75’ Hose Reel
MOUNT
TO
HOLLOW
WALL
AND
MASONRY
WALL
Recommended
tools:
• masking tape
• bubble level
• power drill
• Ø 10mm (Ø 3/8 in) drill bit
• hammer or mallet
• 10mm socket, wrench or adjustable wrench
PAGE
3
the
Moun
ng
Steps
1. Using stud-fi nder, locate stud and mark the loca on.
2. Tape the drilling template on the wall at a convenient height, making sure the holes are centered on the stud.
3. Check the hole centers with the level to ensure they are plumb.
4. Drill (4) four holes with a Φ 3mm (Φ 1/8in) masonry drill bit on the template centers.
5. Fasten the moun ng bracket with four lag bolts and washer to the wall or mber
post.
.
76mm (3")
B.1
CAUTION:
When using power tools such as an
electric drill, please wear eye protection.
WARNING:
Ensure there are no live electrical wires or
plumbing in the wall at the location you are drilling.
Installation:
Wall
Use this method for stone or brick walls...
208mm (8 ")
D
lock washer
nut
expansion bolt
flat washer
80cm (32")
(recommended)
B.1
sleeve
1. Using your electric drill, 10mm (3/8") masonry drill bit and bubble level, drill the hole-
pattern shown, making each hole about 2" deep.
Take
care
to
ensure
that
the
pattern
is
level
.
2. Remove the nut, lock washer, and flat washer from the expansion bolt (B.1).
3. Insert the expansion bolts (with sleeves) into the holes.
4. Mount the Wall Bracket (D) on to the bolts, then assembled the nut, lock washer,
and flat washer. Tighten the nut until the expansion bolt is secure.
5. Hang Hose Reel (C) on wall bracket (D).
6. Connect leader hose to water source.
insert in this
direction
