ENGLISH
Chapter 2
— Getting Started
Note:
Use only 1-inch
DDR SODIMM (200 pin)
modules.
Removing a Memory Card
1.
Turn off the computer and disconnect the AC adapter. Turn the
computer upside down and lay it on a flat surface.
2.
Carefully remove the two RAM compartment cover screws and
remove the RAM compartment cover.
3.
Gently pull tabbed latched in the direction of the arrows (1). The
card will pop up slightly.
4.
Pull upwards on the card and then slide the card out (2).
Inserting a Memory Card
1.
Hold the memory card by its edges with the edge-connector
side towards the slot.
2.
Hold the card at a shallow angle (about 25 degrees) and insert
the edge connector into the connector slot (3). The “gold teeth”
of the edge connector should no longer be visible when the
card is fully inserted.
28
Summary of Contents for eBuddy 7.2
