Operator's Manual
WE43 Series Walk-Behind Edger
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
14
SPARK PLUG
The recommended spark plug is a NGK BM6A which cross
references to a Champion CJ8.
1. Check spark plug at the beginning of each season.
2. Disconnect the spark plug cap, and clean any debris from
around the spark plug area.
3. Remove spark plug and replace if any of the following occur;
pitted electrodes, burned electrodes, cracked porcelain, or
deposits around electrodes.
4. After analysis, seat spark plug and tighten with spark plug
wrench. Reconnect the spark plug wire.
• Reinstall original spark plug, tighten additional 1/2 turn.
• Installing new spark plug, adjust spark plug gap to .028” and
tighten additional 1/8 – 1/4 turn .
NOTE: Loose spark plug may overheat and damage engine.
Over tightened spark plug may damage threads in the
cylinder head.
CARBURETOR
Never tamper with factory setting of the carburetor.
TRANSPORTING YOUR EDGER
1. After using the edger and before transporting it in a truck
bed, screw the fuel cap screw and fuel cap on (clockwise)
tightly. The fuel cap will not leak during transporting if fuel
cap is tight and the screw at the top is tight. Never transport
engine inside an enclosed space within a vehicle. Fuel or fuel
vapors may ignite causing serious injury or death.
2. If fuel is present in the fuel tank, transport in an open vehicle
in an upright position.
3. If an enclosed vehicle must be used, remove fuel into an ap-
proved red fuel container. DO NOT siphon by mouth.
4. Run engine to use up the fuel in the carburetor and fuel
tank. Always run engine in a well-ventilated area.
5. Wipe away any spilled fuel from engine and edger. Allow to dry.
6. Fuel cap and fuel cap vent screw should be turned down
tightly before transporting edger in a vehicle.
LONG-TERM STORAGE
(30 DAYS OR MORE WITHOUT USE)
If your edger will not be used for more than one month, prepare
it for long term storage.
STEPS FOR LONG-TERM STORAGE
1. Add fuel stabilizer according to manufacturer’s instructions.
2. Run engine for 10-15 minutes to ensure that the stabilizer
reaches the carburetor.
3. Remove the remainder of the fuel from the gas tank into an
approved fuel container.
4. Store edger in a vertical position.
5. Remove all debris from edger engine and blade.
CAUTION
TO AVOID INJURY OR DEATH, NEVER SIPHON FUEL BY
MOUTH.
NEVER STORE ENGINE WITH FUEL IN THE TANK INSIDE
A BUILDING. POTENTIAL SPARKS MAY BE PRESENT
FOR IGNITION OF FUEL AND FUEL VAPORS.
COOLING FINS
Cooling fins, air inlets and linkages must be free from any debris
before each use.
AIR FILTER
Never run engine without air cleaner properly installed. Added
wear and engine failure may occur if air cleaner is not installed
on engine.
Service air cleaner every 3 months or after 20 hours of operation.
Clean filter daily in extremely dusty conditions.
IMPORTANT
NEVER TWIST AIR FILTERS WHEN CLEANING. ALWAYS PRESS.
Steps for Cleaning Air Filter (Ring Style Foam Filter) - See
parts breakdown section.
1. Wash in warm water with liquid detergent and water until
dirt and debris are removed. Press filter when washing, do
not twist.
2. Rinse in warm water until soap and dirt are removed.
3. Dry filter by wrapping in a clean cloth and pressing filter un-
til it is dry.
4. Apply a lightweight motor oil or thin based machine oil to
the entire filter.
5. Remove excess oil.
6. Attach the filter and air cleaner cover to the engine
.
