SECTION 5: CARE & MAINTENANCE
CAUTION
- To prevent permanent damage to the hot towel cabinet surfaces, do not use
abrasive cleaners or scrubbers.
- Do not allow acids or acidic products to remain on the warming drawer’s surfaces.
The finish may stain.
DANGER: RISK OF ELECTRIC SHOCK
Always unplug this furnishing from the electrical outlet before cleaning.
Cleaning & Ongoing Maintenance
6
Category
Cleaning Recommendation
Electronics/
Control Panel
Anti-static electronic aerosol dusters can be used to keep the surfaces of elec-
tronic components, power cables, and plugs free of dust. Exercise caution to
avoid introduction of liquids onto any buttons. Do not use abrasive cleaners
or scrubbers. They may permanently damage the finish or damage the letters
and/or graphics.
Cabinet
Exterior
Clean the drawer face/handle with a solution of mild detergent and hot
water. Rinse and dry with a soft cloth.
Cabinet Interior
Clean the cabinet interior with a solution of mild detergent and hot water.
Rinse and dry with a soft cloth. Do not use any flammable cleaners inside the
cabinet.
Gasket
The gasket is located around the edge of the door. Gently clean the gasket
with a solution of mild detergent and hot water. Rinse and dry with a soft
cloth. The gasket material is soft, so be careful not to crush or damage it.
Damaging the gasket will cause a poor heat seal and result in poor warming
drawer performance.
When heating moist towels, condensation can build up inside the cabinet. If not regularly wiped
down, this can lead to small amounts of water dripping from the cabinet when opened.
To minimize any water dripping, ensure you perform the following maintenance tasks as needed
throughout the day:
1) Ensure any condensation and/or moisture (inside and outside the cabinet) is wiped dry with a
soft cloth as needed.
2) Regularly check and wipe down the drip tray.
