EarthCore Isokern Maximus Linear 82L48, Installation, Operation, Maintenance And Owner'S Manual, Page: 22 / 69

Earthcore Industries
Isokern Maximus Linear Series Open Front Gas Fireplace 12/2021
22
NOTE: The underside of the M77
top plate has a stop ledge to seal
the smoke dome; the top side is
flat.
One side of the top plate shows a
thickened center. This side is the
bottom face.
The flue opening in the top plate is
centered in the smoke dome from
side to side but is offset towards
the rear with the center being 10
¾” from the back of the firebox.
FIGURE 16
Isokern Maximus Linear Open Front Installation
7) Set the rear smoke dome component(s) across the damper beam in a bed of Earthcore Adhesive and flush with the back
face of the rear damper beam lintel.
Apply Earthcore Adhesive along the top of the front damper beam along its entire length; bead should be 3” from the
front edge. Place the front smoke dome component(s) on the bead of Earthcore Adhesive so that approximately a 17”
gap exists between the front and rear smoke dome components
(Figure 14)
.
8) With the front/rear smoke dome components in place, apply Earthcore Adhesive to all adjoining surfaces of the sloping
smoke dome sidewall components. The sloping smoke dome side walls will be placed in between the front and rear
smoke dome components at the ends of the firebox and are designed to rest in their notched ends. Once assembled,
compress the smoke dome components by applying pressure to the front/rear of the smoke dome assembly to force the
components together. Repeat this process on the opposite side of the firebox (Figure 15) .
9) Apply Earthcore Adhesive on top of the smoke dome wall assembly and set the top plates into position as shown in
(Figure 16)
.
FIGURE 14
G
FIGURE 15