3
1. Remove all contents from box.
2. Insert end of hose to turbine.
3. Insert hose into spray gun. Push completely
in with slight pressure.
4. Fill cup with solution up to the 4 oz mark.
Use NO MORE than 2 oz per application
applied in two 1 oz coats. Follow the
“Simple Spray Gun Setup Instructions” to
properly set your spray gun up for proper
application. Turn unit on. Test the spray
pattern width on a white cotton towel.
Spray no more than 4 inches away, this
is the same distance you will use when
doing an actual application. Keep the
turbine as far away as possible from the
spray area. The turbine consumes large
volumes of air and if too close this can
cause the turbine to “inhale” the tanning
solution overspray and can cause damage
to the unit. The ON/OFF Switch is located
on the Top of the turbine unit. You will hear
a sound similar to a vacuum cleaner. You
may also notice that air is now blowing
out of the front of the spray gun. This is
correct. Air will continually flow from the
air cap of the spray gun as long as the
turbine unit is running and the air hose
is connected.
SIMPLE SPRAY GUN SETUP INSTRUCTIONS
PROPER SETUP WILL MAKE THE DIFFERENCE
BETWEEN A GREAT APPLICATION AND A
HORRIBLE APPLICATION.
1. Locate the Solution
Flow Screw on the
back of the spray gun.
Part # 8
2. Turn Clockwise to
“Close” and reduce the
spray pattern width, turn counterclockwise
to “Open” and increase spray pattern width.
3. Your goal is a 4 inch wide spray pattern
spraying 4 inches away from the client’s body.
Test on a white (light) towel until this setting
is achieved. A wider pattern will only waste
product. Spraying further away only makes
a mess and again wastes product. THIS IS
THE RECOMMENDED WAY TO SPRAY!!!!!
4. Locate the “Air Cap” (part #2) on the front of
the spray gun. This is where the solution is
sprayed out of the gun. You will see a pair of
“horns”. When these horns are in the vertical
position, you will spray up and down. When
these are in the horizontal position, you will
spray left to right.
5. Simply loosen the air cap ring (part #1) to
adjust the horns in your preferred direction.
There is no “correct” way. What works for
you is all that matters. Tighten the air cap ring
after adjustment.
Quick Tips:
Use no more than 2 oz per application. Using
more is a waste of product with no benefit.
Always do two (2) coats, 1 oz each coat. A
single heavy coat does not work as well as
two light coats.
Best developed colour results will be achieved
by waiting 8-12 hours after application before
first shower.
Apply very little to hands and feet, too much
on these areas never works!!
Your application time should take no longer
than 5 minutes; you will be able to achieve a
2-3 minute application with practice.
If you see “runs” or “beading”... you are
probably going to slow... MOVE THE GUN
FASTER OR ADJUST SOLUTION FLOW
SCREW.
Rinse your spray gun with warm water after
use, that’s all that is needed to keep your
gun clean.
SETUP AND USING YOUR TS20
HORNS IN
VERTICAL POSITION
(Spray Up and Down)
HORNS IN
HORIZONTAL POSITION
(Spray Left to Right)
