![background image](http://html1.mh-extra.com/html/earlex/spraystation-gemini/spraystation-gemini_operating-instructions-manual_3432165012.webp)
12
●
Unscrew Air Cap Ring (2).
●
Remove Air Cap (3).
●
Remove Spray Direction Plate (4).
●
Using Needle and Fluid Tip Tool - pincer end A (1) remove the Fluid Tip (5).
●
Insert Needle and Fluid Tip end B (1) into the inner tube and unscrew the Needle (7) anticlockwise, then pull to release the Needle.
●
Place all of these items into a container and clean, using a brush and the respective thinners.
●
Clean the inside of the body of the spray gun.
●
Thoroughly dry all parts before reassembling.
●
Reassemble parts in reverse order.
●
Ensure Air Cap Ring (2) is fully tightened and Fluid Tip (5) is pushed into place so that the spray gun Needle (7) will shut off.
Tip:
Ensure the Spray Direction Plate (4) is free to move. If necessary loosen the Air Cap Ring (2) slightly.
REPEAT THE SAME PROCESS ABOVE TO CLEAN THE FLUID TIP & NEEDLE.
NEVER LEAVE COMPONENTS SOAKING IN WHITE SPIRITS FOR LONG PERIODS.
DO NOT DISMANTLE THE SPRAY GUN BY UNDOING THE SCREWS.
Cleaning Instructions - Spray Gun
(Fig.25)
2
3
4
5 6
7
8
When removing the needle and fluid tip DO NOT remove the
lip seal from the needle assembly.
HINT:
Before removing or re-inserting the needle and fluid tip ensure the spray gun has been flushed through with water or the appropriate thinners
so the inner tube is clean.
HINT:
The cleaning operation on the spray gun can take less than 5 minutes. If taking a break, leave the spray gun in a plastic bag to prevent the paint
>>> >
from drying.
A
B
1
Fig.25
1
2
3
4
5
6
Fig.25a
Close up view showing alignment of fluid tip (item 5 above)
Summary of Contents for SPRAYSTATION GEMINI
Page 3: ...IMPORTANT INFORMATION Certain coatings may require dilution 08 12 08 12 3 not supplied...
Page 17: ...17 NOTES...
Page 18: ...18 NOTES...
Page 19: ...19 NOTES...