8
PROBLEM
CAUSE
ACTION REQUIRED
The paint runs on the
item being sprayed
Paint too diluted
Add undiluted material
Paint volume too high
Reduce the paint flow by turning Adjuster
Cap (11) clockwise
Moving too slowly
Increase speed of application
Gun trigger held too long
Release Trigger (19) earlier
Gun too close
Increase the distance between gun and
work-piece
Paint is thin or irregular Paint too diluted
Add undiluted material
Paint volume too low
Increase the paint flow by turning Adjuster
Cap (11) anticlockwise
Moving too fast
Reduce speed of application
Gun clogged
Clean the gun
Gun too far away
Reduce the distance between gun and
work-piece
Container not tight onto lid
Tighten Paint Container (16)
No paint being
produced
Paint too thick
Add thinners
Gun clogged
Clean the gun
Pick-up tube clogged
Clean Pick-Up Tube (15)
Air hose split
Replace Air Hose (21)
Grainy paint
Filter the paint
Container almost empty
Refill Paint Container (16)
Gun at an angle
Ensure Pick-Up Tube (15) is angled
towards paint
Air intake blocked
Check no paper or loose debris can block
the air intake underneath the unit.
Clean or replace Filter (20) as necessary.
Troubleshooting
Summary of Contents for Spraystation 5021
Page 11: ...11 Notes ...