ACCESSORIES AND SPARE PARTS
A range of spare parts are available for the CombiVac
TM
. To order please contact our helpline on
01483 454666. Opening Hours:
Monday-Thursday
08.30-18.00
Friday
08.30-17.00
WDACC2 - Deluxe Floor Head
with hard floor, brush and squeegee attachments. Wider head for
greater coverage, suitable for carpets and faster pickup of debris and spills.
WDACC10 - Pack of three spare foam filters.
WDACC11 - Pack of three spare paper filters.
WDACC12 - Power Tool Adapter.
WDACC13 - Combined Wet & Dry Filter
no need for foam filter or paper filter and no need to change
between filters for dry or wet pickup.
WDACC14 - Wide Bore Tool Kit
for larger debris such as rubble and leaves.
WDACC15 - Mini Cleaning Set -
ideal for cleaning/blowing computers, video recorders, air vents in cars.
WDACC16 - Sink Deblocker -
clears blockages from sinks, baths and showers.
MAINS CONNECTION
This unit is a Class II appliance which means it is double insulated for your protection, no earthing wire is
necessary.
If the supply cord is damaged, it must be replaced by a special assembly available from Earlex Ltd or our
appointed agents.
The replacement supply cord is Part No. WD0033.
Your unit has been supplied with a mains lead with a fitted plug. This is identified by the fuse holder in the
base of the plug. Please read the following safety instructions before use.
1. If the fitted plug is cut off from the mains lead then the plug must be disposed of safely.
NEVER
under any circumstances insert such a plug into a 13amp socket.
2.
NEVER
under any circumstances use the appliance or mains lead without the fuse cover fitted.
This is the little cover fixed into the base of the plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our
helpline.
4. A replacement fuse must be rated at 13amp. These must be manufactured and approved to BS 1362.
5.
IF IN ANY DOUBT CONTACT AN ELECTRICIAN.
If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring
instructions below, and will need to be used with a 13amp fuse. If in doubt consult an electrician.
If you are using an extension lead it must be rated at a minimum of 6amps and fully unwound. Do not
operate with a lead rated at less than 6amps as this will cause premature failure of the motor which
is not covered by the guarantee.
As the colours of the wires in the mains lead of the application may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
7
