COMPONENTS
The following components are included in the kit (as illustrated below)
WD0001
Recovery Tank
WD0036
Crevice Tool
WD0026
Extension Tubes x 2
WD0037
Floor Head
WD0029
Paper Filter
WD0045
Castors x 4
WD0030
Foam Filter
WD0048
Hose
WD0032
Rubber Band
WD0082
Motor Housing Assembly
WD0035
Hose Inlet
UNPACKING AND SETTING UP
1) Remove all packing materials and accessories and lift unit out of the box.
2) Release the two tank clips and lift the motor housing off from the recovery tank.
3) Remove all components from inside the tank.
4) Turn the tank upside down and insert the 4 castors. These should be pushed in hard until they stop.
Once installed these remain in place permanently.
5) Push the Hose Inlet into the hole in the side of the Recovery Tank. The Hose Inlet must be pushed in
from the outside of the Recovery Tank ensuring that the lug on the side of the Hose Inlet is lined up
with the slot in the hole in the Recovery Tank. Grasp the Hose Inlet from inside the Recovery Tank and
pull with an up and down motion to engage. Make sure that the clips on the top and bottom of the
Hose Inlet are fixed into place inside the Recovery Tank. Once installed the Hose Inlet can remain in
place permanently.
3
WD0082
WD0048
WD0045
WD0001
WD0026
WD0037
WD0032
WD0036
WD0030
WD0035
WD0029
