ACCESSORIES AND SPARE PARTS
A range of spare parts are available for the CombiPowerVac
TM
. To order please contact our helpline on
01483 454666. Opening Hours:
Monday-Friday
08.30-17.30 (excluding Bank Holidays)
WDACC13 - Combined Wet and Dry Heavy Duty Filter
WDACC14 - Wide Bore Tool Kit
for larger debris such as rubble and leaves.
WDACC16 - Sink Deblocker -
clears blockages from sinks, baths and showers.
WDACC18 - Combispray -
Multipurpose spray gun
WDACC19 - Replacement Dust Collection Bags
WDACC20 - Replacement Cellulose Cartridge Filter
MAINS CONNECTION
This unit is supplied with a mains lead fitted with a fused plug. This is identified by the fuse holder in the
base of the plug. If the supply cord is damaged, it must be replaced by a special assembly available from
Earlex Limited or our appointed agents.
Please read the following safety instructions before use.
1. If the fitted plug is cut off from the mains lead then the plug must be disposed of safely.
NEVER
under any circumstances insert such a plug into a 13 amp socket.
2.
NEVER
under any circumstances use the appliance or mains lead without the fuse cover fitted.
This is the little cover fixed into the base of the plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our
helpline.
4. A replacement fuse must be rated at 13 amp. These must be manufactured and approved to BS 1362.
5.
IF IN ANY DOUBT CONTACT AN ELECTRICIAN.
If you need to fit a plug to the mains lead, this should be fitted in accordance with the wiring
instructions below, and will need to be used with a 13 amp fuse. If in doubt consult an electrician.
WARNING - THIS APPLIANCE MUST BE EARTHED. If you are using an extension lead it must be
rated at a minimum of 13 amps and fully unwound. Do not operate with a lead rated at less than 13
amps as this will cause premature failure of the unit which is not covered by the guarantee.
As the colours of the wires in the mains lead of the application may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol, or coloured green and/or yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
7
EC Declaration of Conformity
We declare that the unit: WD1200P conforms to: 73/23/EEC, EN60335-1 & 2-2 & 89/336/EEC,
EN55014 - 1, EN55014 - 2 EN61000-3-2, 3-3, 4-2, 4-4, 4-5, 4-6, 4-11
Tim Hopper Technical Director
