GUARANTEE
This product is guaranteed for a period of two (2) years against faulty materials and workmanship.The
guarantee specifically excludes the use for hire or rental purposes.
Whilst every possible care is taken by Earlex to ensure that our products leave the factory in good working
order, Earlex cannot under any circumstances accept liability for problems or damage caused by their
subsequent use. Any unit that has been modified in any way or used on incorrect voltage will not be
covered by guarantee. Consumables such as filters are not covered by guarantee. This guarantee does not
affect your statutory rights. In the event of a fault occuring please contact our helpline before returning the
unit to our Service Department at the address below together with a copy of your purchase receipt. All
repairs will be dealt with speedily.
POWER TOOL ADAPTOR
The unit is supplied with a stepped power tool adaptor to fit the exhaust port of many sanders, planers and
jigsaws. To use the power tool adaptor fit the large end into the end of the hose and the smaller end into the
exhaust port of the power tool. Depending on the size of the power exhaust port it may be necessary to cut
the smaller sections from the power tool adaptor.
STORAGE
1) Clean out the container and wipe the surface of the unit over with a damp
cloth.
2) Wrap the mains lead around the upper moulding as shown in illustration and
clip plug to lead.
3) The extension tubes, crevice tool and floor head can be stored either in the
outriggers or on the posts on either side of the top of the unit.
TROUBLE SHOOTING
IF A PROBLEM OCCURS ALWAYS SWITCH THE UNIT OFF IMMEDIATELY
Motor does not operate.
Check unit is plugged in and switched on.
Check fuse in plug - replace only with a fuse of the same rating -
13amps.
If using extension lead check the fuse in this lead.
Check the switch is in position l for use in continuous mode.
Motor operates but cleaner fails Check if the cleaner needs emptying.
to pick up.
Check and clear any blockages within the system.
Check that filters are clean and not damaged.
Check hose is in correct outlet.
Motor makes high pitched noise. Check if cleaner needs emptying and the float valve has operated.
Maintenance
After wet pick up empty, rinse and dry the recovery tank, hose and accessories. If sticky spills, clean the
tank and accessories with warm, soapy water.
Periodically clean the cartridge filter, this will improve its performance. Thoroughly dry before using for dry
pick up.
Do not oil the motor. It is lubricated for life.
There are no serviceable parts inside the cleaner apart from the filters.
AFTER SALES SERVICE
A range of accessories together with all spare parts are available from our service department who will
furnish details for you.
IF YOU REQUIRE FURTHER ASSISTANCE THEN PLEASE CONTACT OUR HELPLINE ON
Tel: 01483 454666 Fax: 01483 454548 email:[email protected]
Opening Hours: Monday- Friday
08.30-17.30 (excluding Bank Holidays)
6
