16
.
Peel off the protective covering from the grille surrounds and use a
mild solvent and a soft, clean cloth to remove any glue residue.
Use alcohol or glass cleaner and a soft, clean cloth to remove any
solvent residue to finish the installation (not applicable on E-Power
mesh grilles).
15
.
To remove the protective masking tape applied in Step 2, you
might need to insert a plastic tool such as a squeegee to seperate
the factory chrome surrounds from the stainless steel surrounds
and pull the tape back over itself to minimize breaking the tape.
14
.
This photo shows the screws and 4-way mesh retainer locations
that will secure the mesh sections to the factory grille inserts (at the
sides of the grille). The screws must be installed on the angled part
where the factory grille is deep enough in order for the clips to hold
the mesh tight against the factory grille insert. You can drill a 1/16”
hole or allow the screws to self tap into the plastic.
13
.
This photo shows the screws and 4-way mesh retainer locations
that will secure the mesh sections to the factory grille inserts (cen-
tered between the middle and sides of the grille). The screws must
be installed on the angled part where the factory grille is deep
enough in order for the clips to hold the mesh tight against the fac-
tory grille insert. You can drill a 1/16” hole or allow the screws to
self tap into the plastic.
11
.
This photo shows the screws and 4-way mesh retainer locations
that will secure the mesh sections to the factory grille inserts (at the
sides of the grille). The screws must be installed on the angled part
where the factory grille is deep enough in order for the clips to hold
the mesh tight against the factory grille insert. You can drill a 1/16”
hole or allow the screws to self tap into the plastic.
12
.
Start at the lower grille center. This photo shows the screws and 4-
way mesh retainer locations that will secure the mesh sections to
the factory grille inserts (left and right below of the factory emblem).
The screws must be installed on the angled part where the factory
grille is deep enough in order for the clips to hold the mesh tight
against the factory grille insert. You can drill a 1/16” hole or allow
the screws to self tap into the plastic.
13
11
14
12
15
