STANDARD FEATURES:
-To ARM the system:
To arm your system within proper operation range, simply press button once (while system in disarmed or
Acc off position) . The system will respond one siren chirp, one lights flash, doors lock, disable engine starter, LED
will begin flashing quickly until all sensor inputs are active - LED will start blinking slowly (flash once per second).
DEFECTIVE ZONE BYPASS:
If armed, after 8sec. the system responds with 4 short siren chirps, it indicating that
one of the door is not close properly. 5 short siren chirps, it indicating that hood or trunk is not close properly. The
system will bypass that zone and still protect other zones.
AUTO RESET:
If a violation occurs the system will respond by sounding the siren and flashing the lights for
approximately 30sec. before the system resets itself and continues to protect your car. If violation still occurs the
system, siren and lights will working for 8 cycles then the system reset itself and continues to protect other zones.
-Arm without siren chirp :
To arm your system without siren chirp , simply press button once then within 3sec. press button once.
Note:
this features is only activated under the system is in disarmed and Acc off position,.
-To DISARM the system :
To disarm your system within proper operating range, simply press button once (while system in arm position).
The system will respond two siren chirp, two light flash, doors unlock, Enable your engine starter, LED off
INTRUSION ALERT:
Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will
Indicates 4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following different
triggering
.
Quick flash 2 times after a pause Sensor 1st-stage triggered
Quick flash 3 times after a pause Sensor 2nd-stage triggered
Quick flash 4 times after a pause Door switch triggered
Quick flash 5 times after a pause Hood/Trunk switch triggered
Quick flash 6 times after a pause Ignition switch triggered
.
-Disarm without siren chirp :
To disarm your system without siren chirp , simply press button once then within 3sec. press button once.
Note:
this features is only activated under the system is in armed position,.
-Arm/Disarm sir en chirp on/off :
(programmable)
The system provide a feature to turn OFF siren chirp when arm/diarm in silent area, disarm the system and turn
ignition to ON position, press and hold button for over 5sec. until siren give 2 short chirps to indicate that the
siren chirp has been turn OFF (disable).
-Automatic REARM:
(programmable)
If programmed with the feature, the system is disarmed by remote and a door is not opened within approximately 40
seconds the system will automatically rearm itself. This feature guards against disarming caused by accidental or
unintended operation of the remote transmitter.
To turn OFF the feature:
Disarm the system, turn ignition from OFF to ON position and within 5 seconds press and
hold button for over 2 seconds, until siren give 2 shot chirps, the feature now has been turned OFF.
To turn ON the feature again, same condition as above, siren give 1 short chirp to indicate turn ON the feature.
-Trunk open:
(programmable)
This negative channel provide 2 ways to active the channel (Trunk open & Remote Latched), a
Note:
if trunk has been remote opened in arming position, hood/trunk switch will delay sensing for 20 seconds, and
the shock sensor will be bypassed.
the channel
may be activated immediately. However the channel may keep outputting until release the button;
this is particularly designed for extra devices operate.
Note:
as long as the channel outputting , the shock sensor will be bypassed , unless button released.
-Dual stage shock sensor:
This device only activates after 8 seconds of arming state; this is preventing from the weak impact caused by the
driver while leaving the car.
The device operates: Light impact will activate the 1st stage sensor by giving 5 warning chirps.
Heavy impact will activate the 2nd stage sensor and trigger the alarm.
NOTE
: Adjustments are made via the rotary control above the shock sensor.
On the contrary, press and hold button 5sec. again, siren chirp will turn
ON again, siren will give 1 short chirp.
lternative feature is
available by programmable setting, please see "Programme mode operate".
-Trunk open :
if programmed with Trunk open feature, simply press and hold button over 2 seconds, the channel
will output for 1 second pulse , normally for open the trunk.
-Remote latched:
if programmed with Remote latched feature, press and hold button , the channel
