POWER CORD.
WARNING:
THERE SHOULD NOT BE ANY DEFORMATION OR DAMAGE ON THE HOUSING, LENS, INSTALLATION
PART, MOVING PART, AND POWER CABLES. IF SUCH DEFORMATION OR DAMAGE OCCURS, STOP THE
DEVICE IMMEDIATELY AND CONSULT YOUR DEALER FOR REPLACEMENT.
REPLACE THE LAMP BY A QUALIFIED PERSON WHEN IT IS DAMAGED OR THE MAXIMUM BULB LIFE,
750 HOURS, HAS BEEN EXCEEDED.
WHEN THE DEVICE IS NOT IN USE, OR YOU NEED TO REPLACE THE LAMP OR FUSE OR ANY PART,
SWITCH IT OFF.
THE DEVICE SHOULD BE ALWAYS EARTHED.
THE POWER SUPPLY YOU USE SHOULD BE COMPLIED TO THE LOCAL CONSTRUCTION AND
ELECTRONIC REGULATIONS. OVERLOAD PROTECTION AND PROPER EARTHING IS A MUST.
AVOID LOOKING DIRECT TO THE LIGHT SOURCE (MEANT ESPECIALLY FOR EPILEPTICS)! AVOID
EXPOSURE NAKED SKIN DIRECTLY UNDER THE LIGHTING BEAM.
WHEN REPLACE THE FUSE, USE SAME TYPE AND RATING FUSE WITH PROPER STANDARD MARK.
AVOID SHORT-CIRCUIT OF THE DEVICE FROM THE TEMPERATURE-CONTROL SWITCH OR THE FUSE!
KEEP THE DEVICE AWAY FROM THE INFLAMMABLE MATERIALS, SUCH AS CLOTH, PAPER, WOOD,
ETC.
KEEP THE FAN OF THE DEVICE AWAY FROM THE WALL OR OTHER OBJECTS. THE DISTANCE SHOULD
BE AT LEAST 0.1 METER.
WHEN THE SURFACE OF THE DEVICE BECOMES VERY HOT, STOP THE DEVICE AND RE-START IT
AFTER AT LEAST 15 MINUTES.
TO REPLACE OR INSTALL THE DEVICE, ALWAYS USE ORIGINAL PART FROM THE MANUFACTURER.
WHEN RIGGING, DEREGGING THE DEVICE, THE WORKING AREA SHOULD BE BLOCKED SO THAT NO
OTHER PEOPLE CAN ENTER.
NEVER PUT YOUR HAND ON THE DEVICE DURING ITS OPERATION.
THE OBJECTIVE LENS, THE EXTERIOR AND INTERIOR OF THE DEVICE WILL BECOME
DIRTY AFTER A PERIOD OF TIME, ESPECIALLY UNDER DUSTY CIRCUMSTANCE. YOU
SHOULD CLEAN THE DEVICE ACCORDING TO THIS USER MANUAL.
SHOOTING CHART
PROBLEM REASON
POWER SUPPLY
NO LIGHT OUTPUT. NO AUTO RESETTING.
POWER INDICATION LED DO NOT LIGHT.
LAMP ON. AUTO RESET. BUT YOU CAN
NOT CONTROL IT. OR YOU CAN NOT
CONTROL A CHANNEL.
LAMP NOT PROPER. YOU CAN NOT
SWITCH IT ON EVERYTIME.
THE LIGHT BEAM SPOT NOT BRIGHT.
LAMP ON, AND OFF AFTER A PERIOD OF
TIME
POWER SUPPLY NOT PROPER. POWER
CORD NOT PLUGGED IN. FUSE FAILURE.
SIGNAL CABLE OR DMX ADDRESS NOT
PROPER. CHECK SIGNAL CABLE OR DMX
START ADDRESS.
VOLTAGE IS TOO LOW. OR THE LAMP
LIFE WILL BE FINISHED.
CLEAN THE LENS. OR THE LAMP LIFE
WILL BE FINISHED.
OVERHEAT PROTECTION WORKING.
CHECK FAN AND VENTILATION.