ASSEMBLY INSTRUCTIONS
QuadPLUS
®
Polymer Dunnage Rack
eG9942 revised 11/18
eagle Foodservice equipment, eagle Mhc, specFAB
®
, and retail Display are divisions of eagle Group. ©2018 by the eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
CAUTION
insPect contents iMMeDiAteLY AnD FiLe cLAiM With DeLiVerinG cArrier For AnY DAMAGe.
SAVE YOUR BOX AND ALL PACKING MATERIALS.
You Are resPonsiBLe For DAMAGe to Your unit iF returneD iMProPerLY PAcKeD.
instruction sheet
#A226046
BEFORE ASSEMBLY, PLEASE READ:
It is recommended to assemble truss frames and/or shelves onto posts—and to secure frame and/or shelf by tapping
with a mallet—BEFORE installing polymer mats. IMPORTANT: DO NOT HIT TRUSS FRAMES AND/OR SHELVES AFTER
POLYMER MATS HAVE BEEN INSTALLED! Remove polymer mats before readjusting truss frame.
(continued on back page)
Thank you for your purchase. Before assembly, read this instruction sheet carefully to ensure correct use.
After reading, be sure to store this instruction sheet in a safe place, should it be needed for future reference.
Stationary Units
Mobile Units
1. Assemble 3-sided frame to posts.
A. Snap plastic tapered split sleeves onto each post at the desired
position for the 3-sided frame (see Figure 1a).
Note: Although the 3-sided frame should be mounted as low as
possible for the most stability, NSF requires a minimum of 6˝
clearance below the frame. For NSF-approved installation, mount
frame at the 6th groove or above on each post.
B. Holding the 3-sided frame on its side, insert the posts through the
corner collars until the split sleeves are seated snugly within the
collars (see Figure 1b).
IF YOU ORDERED A MOBILE UNIT, AFFIX CASTERS TO POSTS…
A. Place donut bumper onto bottom end of each post (see Figure 1c).
B. Insert caster stem into bottom of each post. Drive in caster using a
hammer or mallet (see Figure 1d).
Figure 1a
Figure 1b
split sleeves
3-sided
frame
post
post
corner collar
Figure 1c
caster
post
caster
stem
bumper
Figure 1d
