IMPORTANT NOTE:
Make sure floor is level. If floor is not level, shims are required.
Shim Kit #912991 available upon request.
IMPORTANT NOTE:
Parts List
F . . . . . . . 2 per length . . . . . track
G . . . . . . 2 per track. . . . . . . . extension pins
H. . . . . . . 2 per track. . . . . . . . end stop
I . . . . . . . 2 per track . . . . . . . anchor bolt
J . . . . . . . 2 per track joint. . . . track rivet
K. . . . . . . as required. . . . . . . s/s insert
. . . . . . . . 1. . . . . . . . . . . . . . .
1
⁄
4
˝ drill bit
item
qty
description
Lay tracks (F) on floor parallel to each other. Install stainless steel inserts
(K) to fill track as shown in
figure 1
. For additional track length, place pins
(G) as shown in
figure 2,
to the underside of the track to connect
tracks together.
Note
: Should installation require resizing of the tracks, steel inserts must
run the entire length of the assembled track.
1
Tracks
Place mobile unit on track making sure wheels are in slots. Align each end
and make sure units slide back and forth freely.
Note
: Using a lightly loaded mobile unit will maintain track alignment while
securing track.
2
Mobile Units
Slide one end stop (H) into track end as shown in
figure 3
. Use
1
⁄
4
˝ drill bit
provided to drill straight down into and through end stop and track
(approx. 2˝) into floor as shown in
figure 3a
. Now, hammer securely and
seat anchor bolt (I) until flush as shown in
figure 3b
. Repeat on same end
of opposite track that is running parallel.
Note
:
Keep mobile unit 12˝ to 18˝ from end of track being secured to
insure that distance between each track is correct.
Note:
Use mobile unit to keep track parallel while securing from one end
stop to other.
3
End Stops
At each track joint, slide mobile unit across track joint and stop when track
joint is centered and unit moves freely back and forth.
Using the drill,
position into guide line and drill diagonal through track (approximately 2˝)
from joint seam as shown in
figure 4
. Place track rivet (J) into hole and
secure with a hammer. Repeat procedure on opposite side.
4
Joining Track Lengths
Apply silicone sealant around track edge and floor.
5
Seal Track Perimeter to Floor
figure 2
figure 3b
figure 1
figure 4
figure 3
figure 3a
ASSEMBLY INSTRUCTIONS
High Density Floor-Trak
®
Track Systems
G
H
I
J
K
track joint
hole placement
hole
placement
READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY.
3
