Eagle Bath
Inc.
www.EagleBath.com
9881
6
th
St
#203
Phone:
(800)
576
‐
5011
Rancho
Cucamonga,
CA
91730
Fax:
(909)
941
‐
0200
Page
5
OPERATION GUIDE
OPERATION GUIDE
A. When the bathtub is full of water. Turn on the water pump and/or the air pump, by
pressing the pneumatic button(s) on the sidewall of the bathtub.
B. The working condition of the water pump, air pump, and heat pump, is contingent on
the presence of adequate power supply, secure connections of the pneumatic tubes
and components, and adequate water level.
C. The heat pump contains safety devices which only allow it to turn on when, a) water
pressure is present from the running water pump, and b) the water temperature is
below 104-degrees Fahrenheit.
D. The heat pump is designed to add heat to a body of flowing water, and is only
designed to keep warm water warmer longer.
Warning!
A. Make sure the power wires are complying to the installation diagram before turn the
electrical system on.
B. Do not turn on the Air pump, Water pump, and Heater without water.
C. Make sure the power supply has adequate load capacity and a ground wire.
D. Turn off power when working with any wiring connections.
1. RUN CONDITON
A. Power: AC110V, 50/60 Hz
B. Water pump: AC110V, 6.0-7.0 Amps
C. Air pump: AC110V, 4.0-5.0 Amps
D. Heater: AC110V, 12-14 Amps, 1500w