1.The equipment should be only energized by
authorised person.
2.There should be no electrical load on the busbar system
when it is energized.
3.Hazardous voltages in electrical equipment can cause
severe personal injury or death. Energizing a busbar run
for the first time is potentially dangerous. Therefore system
opertional voltage should be checked .
4.The connected equipment should be energized in sequence
by starting at the source to end of the system.
5.After all overcurrent protection devices have been turned on,
loads such as lighting circuits, contactors, heaters and motors
may be turned ''ON''.
6.EAE busbar system is particularly quiet when operating normally.
In some installations however there may be a moderate hum.
Excessive noise may be an indication of hardware that has not
been tightened or of metal parts that have been improperly
assembled and this should be checked after de-energizing the
system and isolating it safety.
KO-II
MANUAL
Energizing
Energizing The Equipment
ENGLISH
18