EAE EE-612E, Installation, Operation, And Parts Manual

Page: 23 / 41

Installation, Operation and Parts Manual
EE-612E
23
5.3 Operation instructions
WARNING
！
Loads must be centered on platform all times.
Raise the lift
1. Make sure that you have read and understood the operation manual before operation.
2. Park the car on smooth and solid ground and then move the lift with its lifting platform located beneath the car.
3.Adjust the lifting arms until they reach the supporting positions of the vehicle and make sure the gravity of vehicle located mid
way four lifting arms.
4. Connect the power supply as per requirements on the nameplate attached, and switch on. Press the”UP”button on the control box
until pads of lifting arms touched the prop ‐ position of vehicle.
5. Keep on raising the vehicle to let it have a bit clearance from the ground and check again its stability.
6. Raise the vehicle to the desired height, check it is safe or not, press the “Safety Lock” button on the control panel to have the
safety lock engaged, turn off the power and then perform maintenance or repair work underneath.
Lower the lift
1. Switch on.
2. Press the “DOWN” button on the control box. Meanwhile the lifting arms automatically go upwards about 5CM which releases the
safety lock. The lift lowers.
3. After the lifting arms lower to the lowest position, pull them out from under the vehicle and clear up all the obstacles.
4. Drive the vehicle away.
Pos. Name Function
FA Alarm buzzer Safety warning
HL Power indicator Show if electricity is connected
SB1 UP button Control the rising movement
SB2 LOCK button Engage the mechanical lock
SB3 DOWN button Control the lowering movement
SB Emergency stop Cut operation power in emergency case
QS Power switch Control main power