Video in
_
RX2
TX1
GND
VCC 5V
+
VCC
+5V
ANGLE MODE
AIR MODE
AIR MODE
5
SB
Always use caution when flying and operate in an open and controllable area.
Please learn the flight controls first before powering on the aircraft to fly. The
left stick controls throttle and yaw direction of NOVICE-IV. The right stick
controls pitch and roll of the aircraft.
6.Flight and Radio Stick Controls
6.Charger the Lipo Battery
-2-
7.Flight controller connection diagram
8.Binding procedure
5.Toggle the SB switch to change the flight mode(Default is Air mode).We highly
recommend to use Angle mode for the beginners . The motors will auto-spin
when armed if the flight mode is AIR MODE.
Charging Function After insert adapters, chargers "drop" sound, the display
shows ;
Insert the battery charger "drip - drip" twice to start charging. Display cycles
through each section
total battery voltage and the battery voltage;
After the battery is fully charged, the charger automatically stops charging,
the display shows "FULL" And flashing, buzzer once every five seconds.
Voltage Display Function Insert the battery (without connecting adapter),
Right Stick Diagram
Radio Battery Charge
Main Battery Charge
Pitch Down
Left Side View
Forward
Pitch Up
Backward
Left Side View
Roll Left
Left
Rear View
Roll Right
Rear View
Right
Left Stick Diagram
The bellowing content are regard to advanced tutorial. The Novice-IV drone
comes out already finished all the settings and bound with the radio . Need these
content after you re-flashed the firmware or doing some troubleshoot.
Video out
_
GND
VCC 5V
+
Video in
_
TX6
RX6
VCC+9V
GND
IR
GND
+5V
GND
GND
VCC
+5V
LED_STRIP
BUZ-
RX2
TX2
TX1
RX1
BOOT
GND
3-4S BAT+
M3_A M3_B M3_C
M4_A M4_B M4_C
M1_A
M1_B
M1_B
M2_C M2_B M2_A
GND
BAT+
1. Press and hold the BIND button on the receiver then plug the USB to connect
the power. After approximately 3 seconds, the Red LED on the receiver would
be solid ,this indicate the receiver is in bind mode.
2. Select Frsky D8 protocol from the Multi mode and then press [BIND] option,
the red LED on the receiver should blinking fast, this indicate bind is successful.
Unplug the USB and then plug again , the red LED is solid means the connection
with the radio is established.
LED Status Meanings
- Solid: Normal work or
IN Bind mode
Blinking
：
Bind successful
-Turned off: No RC signal
-
Throttle up
Left Side View
Climb
Throttle down
Descending
Left Side View
Yaw Left
Nose Yaws Left
Yaw Right
Nose Yaws Right
