- 4 -
- 5 -
Length
Height
Weight
Length of Main Propeller
Landing gear width
Battery Specification
Flight Time
Main Brushless Motor
Brushless Tail Motor
345 MM
108 MM
131g
320MM
62MM
7.4v 700mah 20C
15-20 Min
050
8520
HELICOPTER PARAMETERS
1. The user should connect to the power adapter with a USB
port or connect to the USB port of computer.
2. Connect the USB cable to the power adapter, at the same
time the USB charger red light flashes.
3. The partial voltage charging head of the battery is connected
with the USB cable. At this time, the USB charger's red light
always on and charging is in progress.
4. When the USB charger red light is off, charging is completed.
To ensure safety, please use the icluded standard charger
WARNING:
lt is recommended to use the original power supply charger whencharging,
otherwise property damage and injury will occur.
Notice:
When it is lower than 7.4V, the lithium battery may be damaged, or itmay no
longer be charged. When the battery voltage is lower than 7.4V when the
aircraft is flying, the power of the aircraft drops significantly.Please immediately
land and charge the battery in time.
WARNING AND THE GUIDE OF BATTERY USAGE
BATTERY CHARGING
7.4V 700mAh
Warning
1. To ensure safety, please charge under the supervision of someone.
2. Children cannot charge alone, they should charge with the assistance of an adult.
3. Please use the original standard charger of this product for charging. The charger of
unknown origin may cause a fre and explosion accident.
4. lt is recommended that users prepare their own 2A current adapter,which will shorten
the charging time.
1. Make sure the battery power is full both for TX and helicopter.
2. Before open the power of TX, please make sure the TH. Stick at the bottom and the
switch of TH.HOLD and 3D mode in back position (back cover direction).
3. Make sure the TX has paired with helicopter ,or please pair them again.
4. Please open TX first, then connect the battery with the RXboard onhelicopter to pair
with TX. When close,please cut the power of helicopter first,and then turn off the TX.
5. Keep away from crowd, cars,high-tension towers and pond.Then you can start your flyirg.
You buy the original model The pairing has been reset before factory. If you need to pair
again, please comply with the following steps.
1. First open the remote control, make sure the throttle joystick is in the bottom position,
3D/ IDLE switch in the OFF position
2. Take down the canopy for touching the code switch.
3. Charge the helicopter,the red lamp flashes slowly, press the code button for 1 second,
then the red lamp will go out and get ready for pairing.
4. When the red and blue lights turn solid, the pairing has been successful.
5. Ensure there are no other remote controllers of the same type at work to avoid interference.
Tips:
This product is compatible with all FUTABA2.4GHZ S-FHSS remote controller.
Notice:
If the throttle of the transmitter has not been positioned at the lowest position
with the throttle switch and 3D mode switch turned on, the transmitter will beep
to prompt you that it fails to proceed to pair.
NOTICE BEFORE FLIGHT
PAIR THE TRANSMITTER WITH THE RECEIVER
Notice:
1. When the remote control is turned on, the throttle hold switch is in the ON state, and
the remote control beeps.The switch should be turned back to the OFF position.
2. When the remote control is turned on, the 3D switch is in the ON state, and the remote
control will beep.The switch should be turned back to the OFF position.
3. When the remote control is turned on, the throttle stick is not in the lowest position, and
the remote control will beep.The throttle stick should be pulled down to the lowest position.
