E2S D1xC1X05FAC115-D, Instruction Manual

Page: 1 / 16

INSTRUCTION MANUAL
D1xC1 & D1xC2
Alarm Horn Sounder & Strobe
Class II & III, Zone 20, 21 & 22
European Safety Systems Ltd. Impress House, Mansell Road, Acton, London W3 7QH www.e2s.com Tel: +44 (0)208 743 8880
Document No. D190-00-351-IS Issue 1 21-03-2022 Sheet 1 of 6
D1xC1-R & D1xC2-R D1xC1-F D1xC2-F
1) Product Table
Unit Type Code
Nominal
Input Voltage
Nominal
Input Current
Voltage Range
Sound
Pressure Level dB(A)
Max* Nom
.†
D1xC1X05RDC024-D 24Vdc 508mA 20-28Vdc
94 90
D1xC1X05RAC115-D 115Vac 200mA 110-120Vac 50/60Hz
D1xC1X05RAC230-D 230Vac 127mA 220-240Vac 50/60Hz
D1xC1X05FDC024-D 24Vdc 508mA 20-28Vdc
98 94 D1xC1X05FAC115-D 115Vac 200mA 110-120Vac 50/60Hz
D1xC1X05FAC230-D 230Vac 127mA 220-240Vac 50/60Hz
D1XC2X05RDC024-D 24Vdc P2/P3: 647/1063mA 20-28Vdc
P2/P3
96/98
P2/P3
92/94
D1xC2X05RAC115-D 115Vac P2/P3: 255/415mA 110-120Vac 50/60Hz
D1xC2X05RAC230-D 230Vac P2/P3: 157/246mA 220-240Vac 50/60Hz
D1XC2X05FDC024-D 24Vdc P2/P3: 647/1063mA 20-28Vdc
P2/P3
106/109
P2/P3
103/105
D1xC2X05FAC115-D 115Vac P2/P3: 255/415mA 110-120Vac 50/60Hz
D1xC2X05FAC230-D 230Vac P2/P3: 157/246mA 220-240Vac 50/60Hz
*Max = Tone 4
†
Nom. = Tone 44
The table shows the input current taken by the various sounders.
The current levels shown above are for the 440Hz Continuous tone @ nominal input voltage.
Nominal current at nominal voltage.
Table 1: Electrical Ratings.
2) Warnings
CAUTION
TO REDUCE THE RISK OF IGNITION OF HAZARDOUS
ATMOSPHERES:
DISCONNECT FROM SUPPLY BEFORE OPENING.
KEEP TIGHTLY CLOSED WHEN IN OPERATION.
WARNING
FIT SEALING FITTING IN CONDUIT RUNS WITHIN 18 INCHES
FROM ENCLOSURE.
EQUIPMENT MUST NOT BE INSTALLED WITH THE HORN FACING
UPWARDS OF HORIZONTAL
DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS
PRESENT
DO NOT OPEN WHEN ENERGISED
POTENTIAL ELECTROSTATIC CHARGING HAZARD - CLEAN
ONLY WITH A DAMP CLOTH
ATTENTION
POUR
REDUIRE LE RISQUE D’INFLAMMATION DES
ATMOSPHÈRES DANGEREUSES :
COUPER L 'ALIMENTATION AVANT OUVERTURE.
CONSERVER FERMÉ PENDANT LE FONCIONNEMENT.
AVERTISSEMENT
CONDUITS DOIVENT ETRE SCELLES EN MOINS DE 18 POUCES.
ÉQUIPEMENT NE DOIT PAS ETRE INSTALLE AVEC LE KLAXON
TOURNEE VERS LE HAUT DE HORIZONTAL.
NE PAS OUVRIR UN PRESENCE D’ATMOSPHERE EXPLOSIVE
NE PAS OUVRIR ENERGIE
DANGER POTENTIEL CHARGE ÉLECTROSTATIQUE - NETTOYER
UNIQUEMENT AVEC UN CHIFFON HUMIDE