E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
E.ziclean vac100 by E.zicom
Manuel utilisateur – User Manual - Handleiding
10. Virtual Wall settings
The virtual wall is an accessory, it sends some special IR signals to form a blocked area to
prevent the cleaner from entering unnecessary areas, it is so named “virtual wall” because
this function acts like a wall.
- Before using the virtual wall, install the batteries as shown in figure 3, open the bottom
cover of the virtual wall, install 2 pcs A batteries (pay attention to the correct polarity).
After the installation,close the bottom cover and tighten the screws.
- Select the distance selector of the virtual wall according to the actual requirements; pull
the shift switch to the top position to select the low level (0-4m), to the middle to select
the medium level (4-7m) and to the bottom to select the high level( above 7m) ; The
lower level, the lower power consumption and the longer working time of batteries,
therefore, you should try to select a lower level whenever possible.
- Press the power button on the virtual wall. The indicator will flash. When the voltage is
normal, the indicator will twinkle at each longer interval, if the batteries are in low power,
the indicator will flash faster, indicating that the batteries should be replaced. To avoid
wrong startup, you should press and hold the switch for a comparatively longer time
(about 3~5 seconds) when turning on the power.
- The virtual wall takes effect with IR signals, therefore, its functional range is a sector of
about15°, when the power is turned on, you should place it at the entrance of the area
that you don’t want thecleaner to clean. The cleaner won’t enter such area then.
- The virtual wall uses 2pcs A (1.5V)batteries, when batteries’ power is short, you should
replace them. Continue to use the batteries with extremely short power may corrode the
virtual wall.
