MAINTENANCE PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Page 48
Owner’s Guide
As a final check, check the oil level again with the vehicle on level ground. Like all liquids, oil increases in volume when warm.
The full ‘H’ mark on the dipstick is calibrated for an engine at operating temperature. When the engine is cold, the oil will be
below the full mark. The engine can be operated safely as long as the oil is within the safe operating range as indicated on the
dipstick.
Do not operate vehicle if oil level is below the safe area indicated on the dipstick.
STARTER/GENERATOR BELT TENSION
Tool List
Qty.
Belt tension gauge .................................................................................................................................................. 1
Wrench, 3/4" ........................................................................................................................................................... 1
Wrench, 9/16" ......................................................................................................................................................... 2
Ratchet, 3/8" drive .................................................................................................................................................. 1
Socket, 3/4", 3/8" drive............................................................................................................................................ 1
The starter/generator belt tension should be checked after the first 15 - 20 hours and set to 75 - 80 lbs. (34 - 36 kg)
A loose belt can cause audible vibration and squeal.
Tighten a
new
starter/generator belt to 115 - 125 lbs. (52-57 kg) tension when a gauge is applied half way between the two
pulleys.
A
new
belt may be checked manually. A maximum deflection of 3/8" (10 mm) is acceptable. Tighten an
existing
belt to 75 - 80
lbs. (34 - 36 kg) tension using the same technique and inspect for cracking or wear. A maximum deflection of 1/2" (13 mm) is
acceptable.
Adjusting The Belt
Loosen the starter/generator pivot bolt.
While holding the lower adjusting nut with a wrench, loosen the upper jam nut with another wrench. Move the lower nut up or
down the adjustment bolt until proper belt tension is achieved. Hold the lower nut in place and tighten the upper jam nut
against it.
3/8" (1 cm) Maximum
Deflection (New Belt)
1/2" (1.3 cm) Maximum
Deflection (Existing Belt)
Summary of Contents for Shuttle 22 TXT - Electric
