Page K-2
DIRECTION SELECTOR
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
B
Installation of the direction selector assembly and han-
dle are the reverse of removal. Tighten hardware to the
specified torque.
Micro Switch
Before removing a suspected faulty micro switch,
ensure the electrical wires are firmly attached and the
wires are in good condition.
Remove the direction selector assembly from the vehi-
cle. Remove two nuts (4) and screws (5) that secure the
micro switch (5) to the bracket. Carefully remove the two
electrical wires from the micro switch. Connect the wires
to the new switch and using a DVOM, test the switch to
ensure it is operational before continuing. Once it is
determined that the switch is functional, continue reas-
sembly of micro switch to the direction selector bracket.
Install the direction selector assembly in the vehicle and
install the direction selector handle. Tighten all hardware
to the specified torque value.
Fig. 3 Micro Switch
Shift Cable Adjustment
The single cable direction selector is a mechanical
device that operates a cable connected to the rear axle.
The cable is sealed and does not require lubrication.
Required adjustment should be minimal. Adjust the
threaded fitting at the forward cable mount while selec-
tor is in the ‘REVERSE’ position until direction selector
cam will contact both stops, or contacts the reverse stop
and maintains no more than an 1/8” gap at the ‘FOR-
WARD’ stop. If further adjustment is necessary, adjust
threaded fitting at the rear axle cable mount. Lubricate
the direction selector, linkage and related moving parts
periodically.
Neutral Lock Operation
(Ref. Fig. 4)
The neutral lock is located on the direction selector. To
operate the neutral lock, first turn the key switch to
‘OFF’, place direction selector in ‘R’ and remove seat.
Pull out (1) and rotate (2) the neutral lock pin handle so
that the pointed portion of the handle is over the side of
the direction selector cam (Ref. Fig. 4). Move direction
selector lever towards the area between ‘F’ and ‘R’. Dur-
ing that motion, the pin will snap into a hole in the direc-
tion selector mounting bracket, preventing any
movement of the lever. When in this position, the direc-
tion selector remains locked in the neutral position.
Spring loaded mechanism. To prevent possibil-
ity of fingers becoming pinched in the direction
selector mechanism, hold direction selector
lever when releasing neutral lock pin handle.
.
Fig. 4 Neutral Lock
To activate the direction selector, pull the neutral lock pin
handle out (1) and rotate (2) until the pointed portion of
the handle fits into the hole (3) in the direction selector
cam.
ITEM
TORQUE SPECIFICATION
1
15 - 20 in. lbs (1.7 - 2.3 Nm)
3
62 - 71 in. lbs (7 - 8 Nm)
ITEM
TORQUE SPECIFICATION
4
4 - 5 in. lbs (0.5 - 0.6 Nm)
5
6
4
2
1
Summary of Contents for RXV GASOLINE
Page 1: ...RXV GASOLINE SERVICE REPAIR ISSUED FEBRUARY 2009 REVISED APRIL 2010 611104...
Page 6: ...Page iv Repair and Service Manual TABLE OF CONTENTS Notes...
Page 10: ...Repair and Service Manual Page viii SAFETY INFORMATION Notes...
Page 178: ...Page T 4 Repair and Service Manual VEHICLE WARRANTIES Notes...
