User Manual
EW-M48
11
1. First read and fully understand this manual.
2. Mount all the electrical parts of the wheelchair system (motors, park brakes, ba�eries, Power
Module, Remote) on the wheelchair. for the physical dimensions of the LiNX LE System Power
Module, Remote and moun�ng rec-ommenda�ons.
3. Do not connect any cables before all the parts of the electrical system are mounted.
4. Connect the LiNX LE System Power Module to the motors the park brakes and the Remote.
5. Connect the LiNX LE System Power Module to the ba�eries.
Do not turn on the wheelchair yet.
1 Installa�on procedure
Warning:
Do not connect the positive terminal (B+) of the battery to the LiNX LE System Power Module until the
wheelchair is completely wired and ready for testing as described in the Testing section.
6. Li� the wheelchair off the ground and check the installa�on thoroughly.
7. Program the system to the requirements of a par�cular wheelchair or user.
8. Test the system for func�onality and safety.
Figure 14:
Power OFF
Figure 15:
Power ON
2.1.1 Power up / down
To switch ON the LiNX LE System, press the Power bu�on. The Power bu�on is the
only user input that can ac�vate the system.
If the system is healthy, the Status indicator (through the Power bu�on) will light up
green, and the Ba�ery Gauge will display the current ba�ery status.
If there is a fault with the system when powering up, the status indicator will indicate
the fault with a series of red flashes (see sec�on 3 Diagnos�cs). If the fault is one
that prevents the system from driving, then the ba�ery gauge will flash
con�nuously.
To switch OFF the system, press the Power bu�on; the system will power down and
the Status indicator will switch off.
The Power bu�on is also used to perform an EMERGENCY STOP. See next sec�on.
Note:
In the unlikely event that the wheelchair is in a runaway situation, the user can press the Remote's power button
to perform an EMERGENCY STOP. See section 2.1.2 Emergency stop
See also:
2.1.9 The status indicator on page 13
