Digital Projection
E-Vision Laser 6500 Series
Rev A April 2016
Page 14
Important Information
Connecting the power supply
Firmly push the mains connector
into the socket as shown in the
illustration.
Use only the power
cable provided.
Ensure that the power
outlet includes a ground
connection as this equipment MUST be earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Switching the projector on
1. Connect the power cable between the mains supply and the projector. (See
Connecting the
power supply
above.) Switch on at the switch next to the power connector.
2. The
POWER
indicator lights red to signal that the projector is in STANDBY mode. Press one of
the following buttons:
•
On the remote control, the
ON
button
•
On the projector control panel, the
POWER
button .
The
POWER
indicator begins flashing green. In approximately 30 seconds, the startup screen
appears and the projector is fully switched on.
The first time you use the projector, you can set OSD language from the quick menu. (See
Setting the OSD language
in the user manual.)
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm
your choice.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.