E-TON Beamer, Owner'S Manual

Page: 12 / 25

Page 11 Rev 3.01 8-0904
Changing Transmission Oil
1. Place an oil catch pan under the unit
directly below the transmission box.
2.
Remove the transmission box drain
plug located on the bottom of the
transmission box on the (LH) side of
the engine.
3.
Remove the transmission box fill hole
plug locate on top of the transmission
box on the (LH) hand side of the
engine
4. Allow the oil to drain completely (15-30
min).
5.
Reinstall the drain plug and tighten.
Torque to 7-10lbf-ft
6.
Fill the transmission box with of SAE
80-90 gear oil (100cc / 3.4oz )
7. Reinstall the fill hole plug. Torque to 2-
3ibf-ft.
8.
Dispose of used oil at a proper
recycling station as required by law.
Tires and Wheels
The tires and wheels of your Beamer have been
engineered to match the suspension to give you a
smooth, comfortable ride. They were also
designed to afford you with mileage economy, to
give you the best miles per gallon possible.
Tire Size & Pressure
Recommended tire pressure (Cold) is:
Front 120/90-10 18psi / 1.25kg/cm
2
Rear 130/90-10 25psi / 1.75kg/cm
2
Spark Plug
Replace the spark plug every 10,000 miles or
if the plug should become damaged or fouled.
We recommend that you use NGK -
BPR7HS.
Disconnect
spark plug
wire.
Clean dirt
from around
spark plug
base with
brush or air.
(Caution: do
not allow dirt
or foreign
material to
enter the
engine)
Remove spark plug with spark plug wrench.
Set the spark plug gap on the new plug to
0.023”.
Install the new plug screwing it in finger tight
and then use the plug wrench to screw the
plug in another ½ turn.
Inspect the spark plug wire for cuts, nicks or
other damage. Replace as needed.
Air Filter
Air Filter Maintenance
To maintain the highest performance from your
engine and to reduce excessive wear that
could cause engine failure the engine requires
a continuous flow of clean air. Air is taken into
the engine through an air filter to clean the air
prior to mixing it with fuel and oil in the
carburetor.
During normal operation the filter
accumulates dirt from the air and will need to
be cleaned to maintain the proper air flow.
The filter should be cleaned every 3000
miles, more often if you ride in a dusty or
dirty environment and the element should be
replaced every year.
Copyright ©2008-2009 ETON America, all rights reserved.