E-Tech DrivE-Tech 015, Installing And Operating Manual

Page: 21 / 33

21
parameter
defa
ul
t
desciption
Co
n
stan
t
val
u
e
Fi
x sp
e
e
d
Co
n
st.
val
u
e
2
set
Fi
x sp
e
e
d
2
val
.
Exte
rn
al
sp
e
e
d
By selecting N.C. (normally closed)
DrivE-Tech runs the motor if the digital
input 3 is closed; motor will be stopped
if the digital input 3 is opened.
N.O.
By selecting N.A. (normally open)
DrivE-Tech runs the motor if the digital
input 4 is open; motor will be stopped if
the digital input 4 is closed.
By selecting N.C. (normally closed)
DrivE-Tech runs the motor if the digital
input 4 is closed; motor will be stopped
if the digital input 4 is opened.
    
3
Digital input IN2 and IN3 delay.
Digital input IN1 and IN4 have 1 second
fix delay.
    
Pressing ENT allows the installer level
password (1st level) (default 001) to be
changed.
    
6.6 Advanced parameters
All the advanced parameters, due to their importance, are already set during initial setup (
cap. 6.2 Initial Configuration) .
However, it is always possible to modify individual parameters or modify the password 2:
Parameters Default Description
XXX Motor rated voltage (as shown in the motor plate)
Average voltage drop due to the inverter is between 20 V and 30 Vrms
based on load condition.
1% Refers to the voltage increase during the start up of the motor.
Warning: An excessive value can seriously damage the motor. Contact the
motor manufacturer for further information.
If a single-phase motor is used, a value of 1% is suggested to increase the
starting torque.
XX Rated current of the motor per it’s nameplate indication increased by 10%.
The voltage drop caused by the inverter leads to higher input current than
nominal. Make sure motor is capable of accepting increased current.
50 Rated frequency of the motor per its nameplate.
50 Maximum frequency of the motor. Note: by reducing the maximum
frequency of the motor, maximum current will be reduced as well.
Max motor freq.
f = XXX [Hz]
Rated motor freq
f = XXX [Hz]
Rated motor Amp.
I = XX.X [A]
Voltage boost
V = XX [%]
Rated motor Volt.
V = XXX [V]
Change PASSWORD1
ENT
Dig.In.2/3 delay
t= XX [s]
Digital input 4
N.O. / N.C.