10
5. DrivE-Tech installation
DrivE-Tech can be installed directly on the fan cover
of the motor
or mounted on the
wall.
Motor mounting kit
In this application DrivE-Tech is cooled by the motor fan. Motor kit (available upon request) allows a solid coupling of the two
units and it is composed of:
DrivE-Tech 015,030,022,040
DrivE-Tech 055,075,110,150
n.°4 rods
n.°4 M5 nuts
n.° 4 hooks
n.° 1 cooling ring
n.° 4 M5 screws.
n.° 4 clamps
n.° 4 clips to add if necessary
n.°1 centre pin
Use the cooling ring for best cooling of DrivE-Tech during
operation. Warning: when using the cooling ring, the
cooling air of the motor is slightly warmer than without
the DrivE-Tech; if the resulting motor temperature
exceeds the indicated maximum allowable value, remove
the cooling ring, leaving the DrivE-Tech to be cooled by
itself.
