ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014
20
CLEARING A SINGLE TRANSMITTER BUTTON CODE FROM THE RECEIVER MEMORY.
This can only be completed if the remote control that must be erased is present.
If the remote control that must be removed is missing or unobtainable, then a master erase procedure
(Page 21) must be performed and the remaining, valid user codes must all be learnt into the memory once
again.
From Standby Mode
Action
Response
To enter the Program
menu. Press and hold SET
button until buzzer beeps
twice.
Display begins flashing
“P” and buzzer beeps
twice to confirm the
main program menu is
active.
Select receiver setup by
scrolling up with the UP
button until “r” flashes.
Display flashes “r” to
confirm receiver setup
mode is selected.
Press and release SET
button to enter receiver
setup.
Buzzer beeps once and
“b” is displayed.
Press and release the UP
or DOWN buttons to
scroll to the “C” option.
“C” is displayed.
Press and hold desired
remote button to be
erased.
LED on remote
transmitter illuminates.
While still holding the
desired button, press
and release SET button.
“0” on display and 1
beep = user code
successfully erased.
“3” on display and 3
beeps = Unsuccessful
because no code was
seen within 4 sec of the
SET button being
pressed.
Mandatory timeout.
Release the remote
button
Display reverts back to
flashing “r” to indicate
you have returned to the
receiver setup menu.
Unsuccessful
Scroll up or down
to next program
option.
OR
Press and release EXIT to
return to Standby mode.
