PITCH TRIM KNOB
PITCH
0
Point
Output Value
1
2
3
H
L
0%
50%
100%
The pitch trim knob is a trimmer for the pitch channel .This knob
should be set to at first ,then adjust the rotor RPM by shifting
it upward or downward.
As the setting of each manufacturer is different ,only small trim
adjustment will be required if the pitch curve had set properly.
Before any adjustment, please set all the switches in the front of the transmitter to the lowest(normal)
position.
Turn on the power switch of the transmitter and the receiver , then make the following adjustments:
THR
ELE
AIL
RUD
AIL :
ELE:
THR:
RUD:
REV:
NOR:
Channel display
AIL : Aileron(channel 1)
ELE: Elevator(channel 2)
THR: Throttle(channel 3)
RUD: Rudder servo(channel 4)
Rudder operating display
REV: Reverse
NOR: Normal
Check the direction of each servo, If a servo operates in the wrong direction, switch its SERVO
REVERSR switch (the direction of operation can be changed without changing the linkage.)
2.Check the aileron, elevator and rudder neutral adjustment, if the neutral position changed,please reset
and readjust it ,make the servo horn to be perpendicar to the servo.
3.Check to see whether the operation of each direction is normal, if not ,please adjust the SERVE
REVERSERswitch (For 6CH transmitter ).
2.4G
2.4G TRANSMITTER INSTRUCTION MANUAL
15
2.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.