E sky 150 V3 Series, User Manual

Page: 12 / 32

10
EN
Throttle Cut
Throttle cut is used to turn off the motor quickly if the helicopter is out of control. The motor will stop spinning and
disable of throttle control when throttle cut is switched to RED dot position, the motor will continue to spin at low idle
speed and control by throttle when throttle cut is switched to GREEN dot position and the throttle at the lowest
position. If throttle cut is switched to GREEN dot position and the throttle position is
NOT at lowest throttle, the motor
will still spin at low idle speed but out of throttle control until the throttle moves to the lowest throttle.
Press and hold the
power switch
Push and hold the
Rudder Trim to the Right
1) Power off the transmitter and power on the helicopter, the LED
(Green) in the helicopter flashes rapidly which shows the helicopter
is in bind mode.
2) Push and hold the rudder trim to right, then press and hold the
power switch of the transmitter.
3) The LED (Green) in the helicopter will glow solid when binding is
complete. Then release the rudder trim button and power switch.
(Helicopter was completely bound in the factory setting.)
Transmitter and Receiver Binding
Transmitter Low Voltage Warning
The LED (Blue) flashes slowly when the transmitter battery voltage is low. Replace the transmitter battery as soon
as possible to prevent affecting normal operation.
When the LED (Blue) flashes slowly with beeps during flight, land the model and replace the transmitter battery
immediately. Failure to do so will probably result in destruction of the model and possibly bodily injury!
Please use the provided screwdriver to install all the screws. Other tools can damage the screw and the helicopter.
Maintenance Tool