11
E-MORE TV LIFT 650 / 1000
REMOTE CONTROL REPLACEMENT
After replacing the remote control, matching of the 2 devices is necessary.
matching-process:
1. Deactivate the power of the TV mount.
2. Press and hold the Up key on the remote controller and reactivate the power.
3. After hearing two "di"-sounds, press the Stop key.
4. After hearing two "di"-sounds, press the Down key.
5. Two "di"-sounds can be heard again. The matching is completed and the remote controller is ready to use.
CORRECT DISPOSAL
This sign indicates that this product must not be disposed through regular household waste within the European
Union. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. There you can obtain all
information necessary to dispose of this product properly. (WEEE-Reg.-Nr. DE: 52242201)
SAFETY AND WARNING!
This product can be used by children age 8 years and older, a persons with reduced physical, sensory or mental capacity as
long as they have been given proper instructions / training on how to use the product in a safe way and understand the haz-
ards involved. Children shall not play with the product.
TROUBLESHOOTING
Error Code
Possible Cause
How To Correct
E01, E02
Cables are not connected or broken
the weight of the desk exceeds 60/80 kg
Connect cables properly, if problem persists change engine
Remove weight
E07
Load weight exceeds 60/80 kg
Remove weight
E08
Input voltage lower than required
Improve the input voltage
E09
Input voltage higher than allowed
Lower the input voltage
E10
Control panel is not connected or does not
receive power
Wait 1 second for the error code to disappear
If it persists check the connection cables
RES
Reset is required
Hold the "Down"-Button for a while. The mount will lower to the
minimum height.
HOT
Excessive use
Do not use for 18 minutes. System will recover automatically.
ATTENTION!
DO NOT install upside down. (e. g. installation on the ceiling) It will cause damage to the product and TV.
