E-matic PMCSF6 Manual Download Page 3

SETTING THE LIGHTING SYSTEM

 

 

(1) TEST 

MODE 

„

  Turn the Lux control and the Time control counter-clockwise to the edge - the 

TEST position. (FIGURE 7)

 

 
 
 
 
 
 
 
 

                                          FIGURE 7 

„

  Turn the power supply switch on, the light will turn on immediately and wait 

for about 1 minute to warm up the unit.    After warm-up time is expired and 
the light goes off, you may do a walk test and the light will turn on.  This 
confirms that the wiring is correct and that the light is working. 

 

„

  Walk through the coverage area.    The light will turn on for about 5 seconds 

when motion is detected and turn off shortly after motion stops.    Wait for the 
light to turn off before

 

moving again to test the sensor. 

 

(2) SETTINGS 
 

„

 

TIME ADJUSTMENT 

 

The TIME adjustment controls how long the light will stay on after motion has 
been detected. 
 
Adjust the TIME Control Knob clockwise to increase the turn-off time (40 minutes 
maximum) or counter-clockwise to decrease the turn-off time (5 seconds 
minimum). (FIGURE 8)    There are ten selections for time adjustment (from MIN 
to MAX) -- 5, 10, 20, 40, 80, 160 second and 5, 10, 20, 40 minute.   
 
 
 
 
 

                             

                                                                              FIGURE 8 

 

„

 

LUX ADJUSTMENT 

The LUX adjustment determines at what light level the light will start operating 
when you set the sensor to the AUTO MODE. 
 

 
 

 

                                              FIGURE 9 

 
Provisionally turn the LUX Control Knob to the edge clockwise at the moon (dusk) 
position. (FIGURE 9) In this provisional setting mode, the Motion Sensor remains 
inactive during daylight.    At dusk when you find it is the LUX level you desired for 
operation, simply set the LUX control knob to the position that you tried 
satisfactorily. 
 

OPERATION

 

„

 

Automatic Operation 

When the sensor detects motion, the light automatically turns on.  The built-in 
photocell turns the sensor off and on according to the light level selected by the 
LUX adjustment. 

 

TROUBLESHOOTING

 

Light does not turn on 

z

  Confirm that you have mains at the fitting and connections are correct

z

  Make sure that the bulbs have not burned out. 

Light remains on 

z

  Make sure the wiring connection is correct. 

z

  Check if the TIME /LUX settings are correct.

 

         
 
 
 
 
 
 
 
 
 

 

About 5sec

About 40min

 

Reviews: