e-Joe ANGGUN, User Manual

Page: 10 / 21

10

Once the bike is powered ON and the red throttle button is engaged, when the rider twists the twist
throttle, the bike will move forward! Do not turn the power ON until you are ready to go.
o
Using the hand brake or releasing the throttle will automatically cut the power to the motor.

To get the furthest distance range, it is recommended to pedal the bicycle with the Pedal Assist System
mode ON.

When riding down hills, do not turn off power. Doing so can easily damage the controller and motor.

When riding your e-bike when the battery power is low, it is recommended to pedal your e-bike as
much as possible and charge the battery as soon as you get to an electrical outlet.

Turn off the power and remove the key while parking. If you decide to push your bike for any reason,
make sure to turn the power off so you don’t accidentally turn the throttle on and make the electrical
bicycle start suddenly and cause an accident.
 To help get the best distance out of your electric bike, refrain from unnecessary braking and coast as
much as possible.
Installing the Batteries of the LED Lights
Front LED Light batteries
The batteries of the front LED light come pre-installed.
To replace the batteries: The front LED light sits on a small track so that the light can be easily removed. Press
the lever that is behind the front LED light in a downward position. Pull the light forward off of the track. Insert
3 AAA batteries. Turn the front LED light on and off using the power button sitting on top of the light.
Installing the Rear LED Light
The batteries for the rear LED light are not preinstalled. You will need to insert the batteries that are included
in the packaging of your brand new ANGGUN.
To insert and replace the batteries: Reach under the rear light. There is a piece that will stick out farther than
the sides. This is the removal lever. Pull the lever straight back and then upward. Insert the 2 AA batteries that
are included with your brand new bicycle. Turn the rear LED light on and off using the power button sitting on
top of the light.
Using the Kickstand
The ANGGUN is equipped with a stabilizing kickstand that aims to support both sides of the bicycle.
Secure the Bicycle for Kickstand Maneuvering
Place one hand on handlebar and the other on the seat to stabilize the bicycle